Problems using VE AIMS 2

[Coxmmeister]

Hi,

I'm really getting frustrated now as when I put in my PO, I cannot drag the lines anywhere. When I do it says modify order, I click and say yes and it says order modified and then it goes back to the original settings.
Any help would be appreciated. I run MT4 with Alpari as the broker.
It's getting so frustrating, please any ideas?

(angry) (angry) (angry) (angry) :ymsigh: :ymsigh:

[immy]

Hi,

I'm really getting frustrated now as when I put in my PO, I cannot drag the lines anywhere. When I do it says modify order, I click and say yes and it says order modified and then it goes back to the original settings.
Any help would be appreciated. I run MT4 with Alpari as the broker.
It's getting so frustrating, please any ideas?

(angry) (angry) (angry) (angry) :ymsigh: :ymsigh:

Hi

Please check there must be ve aims attached to another chart window of the same currency. If you use ve aims (dragging lines type) on two charts it creates problems as both charts have lines that contradict. It can be used on only one chart same goes for VE AIMS 2, and most trade management EA's should not be applied to more than one chart of the same currency.

i hope this helps.

btw: We do not need VE AIMS any more as MT4 has these features built into it.

cheers

[Coxmmeister]

Hi Immy,

I only have 5 min usd/jpy and 5 min eur/usd. I am still getting the same problem.
How do I get the MT4 EA?
Thanks in advance

Jason

[Darren]

I would totally remove the VE AIMS EA from the charts and you should still see lines on the chart as they are usually set on by default. Make sure the 'Show Trade Levels' is clicked on if the lines are not shown.

[Coxmmeister]

Many Thanks.
I have now removed VE AIMS and now can drag the levels.
Happy days.

Thanks you :-bd